Structure Of The Reducer

Mar 04, 2025 Leave a message

The reducer is a device widely used in mechanical transmission. Its main function is to reduce the speed and increase the torque. Its structure is complex and precise, and is usually composed of the following core parts: ‌

1. ‌Transmission parts‌
‌Gear or worm‌: This is the core component of the reducer. The speed is reduced and the torque is increased through the meshing of gears or worms. Gear reducers usually consist of a driving gear (pinion) and a driven gear (large gear), while worm reducers consist of a worm wheel and a worm.
‌Gear shaft‌: In some designs, the pinion is made into one piece with the shaft, called a gear shaft. This structure is suitable for situations where the diameter of the gear is not much different from the diameter of the shaft.
2. ‌Shaft and bearing‌
‌Shaft‌: It is used to support and fix the gear and transmit torque. The design of the shaft needs to consider strength and stiffness to ensure that it will not deform or break during high-speed operation.
‌Bearing‌: Reduce the friction and wear of the shaft during rotation to ensure the smooth operation of the shaft. Depending on the load, deep groove ball bearings, angular contact ball bearings or tapered roller bearings may be used.
3. ‌Casing‌
Casing‌: As the main supporting structure of the reducer, the casing bears the pressure of all parts, so it must have sufficient strength and rigidity. The casing is usually made of gray cast iron or cast steel, and in some cases, a steel plate welded structure is also used.
‌Sealing and lubrication system‌: A lubrication system is installed inside the casing to ensure that the gears and bearings are fully lubricated, and the sealing elements are used to prevent the leakage of lubricating oil and the entry of external dust.
4. ‌Accessories‌
‌Inspection hole and breather‌: Used to check the meshing of the gears and inject lubricating oil. At the same time, the breather is used to balance the pressure inside and outside the casing to prevent lubricating oil leakage.
‌Oil mark and drain plug‌: The oil mark is used to observe the amount of lubricating oil, and the drain plug is used to discharge dirty oil when changing the lubricating oil.
‌Bearing cover and positioning pin‌: The bearing cover is used to fix the axial position of the shaft system components, and the positioning pin ensures the precise alignment of the casing cover and the casing seat.
5. ‌Other structures‌
‌Lubrication method‌: Depending on the speed and load of the gear, thin oil lubrication or grease lubrication may be used. Thin oil lubrication is carried out by the lubricating oil splashed by the rotating gear, while grease lubrication is suitable for low speed or high load conditions.
‌Oil retaining ring and sealing element‌: During grease lubrication, the oil retaining ring is used to prevent the thin oil from washing away the grease, and the sealing element prevents the loss of lubricating oil and the entry of dust.
Through the design and combination of the above structures, the reducer can efficiently and stably achieve the functions of speed reduction and torque increase, and is widely used in various mechanical transmission systems.