The maintenance cycle of reducer mainly includes oil change cycle and inspection cycle.
Oil change cycle
New reducer: After the running-in period of 7-14 days (150-300 hours), new oil needs to be replaced. The second oil change must be carried out after 3 months of use. After that, it is recommended to change the oil every 6-8 months for reducers that work continuously for a long time, and every 10-12 months for reducers that work no more than 8 hours a day.
Special circumstances: If the oil contains impurities, is contaminated or decomposed and aged, it must be replaced at any time.
Inspection cycle
Daily inspection: It is recommended to check the appearance of the reducer before starting the machine every day, such as whether there are abnormal phenomena such as oil leakage and cracks.
Weekly inspection: Check the oil level, bolt tightness and operation of the transmission parts of the reducer every week or every two weeks.
Monthly inspection: Carry out a more comprehensive inspection of the reducer every month or every quarter, including gear wear, bearing working condition, etc.
Maintenance precautions
Lubrication management: Ensure that the oil is added to the specified position, replace the lubricating oil regularly, and ensure that the new oil is the same brand as the original oil used, and avoid mixing different brands and types of lubricating oils.
Transmission parts: Regularly check and repair the transmission parts. If the gears are found to be scratched, glued, or significantly worn, effective measures must be taken. The replacement spare parts must be manufactured according to the standards and can only be officially used after running-in and load testing.
Bearing inspection: Regularly check the temperature, noise, and vibration of the bearings. If abnormalities are found, they should be replaced in time.
Seal inspection: Regularly check the sealing performance of the reducer to prevent lubricating oil leakage. If the seal is damaged, it should be replaced in time.
Operating environment: Keep the outer surface of the reducer clean, and the vents must not be blocked; the rotating part of the reducer that leaks out should be equipped with a protective cover, and it should be grounded when connected to the motor or other electrical equipment.






