The maintenance cycle of worm gear reducer mainly includes the following aspects:
Regular inspection and maintenance: It is recommended to conduct a small inspection every 3 to 6 months, including whether the bolts are loose, whether the working temperature is normal, and whether there are leakage and oil leakage; at least one major inspection is carried out every year, focusing on the state of seals and the wear of transmission parts.
Lubricant management and replacement: Lubricant plays a role in reducing friction and loss in worm gear reducer. It is generally recommended to replace lubricant once every 10,000 hours of operation or once a year (adjusted according to specific circumstances), and ensure that the oil level is sufficient and clean without impurities. For arc cylindrical two-stage worm reducer, the lubricant needs to be replaced after 300 hours of operation, and then replaced every six months or 4,000 hours of operation. When replacing, the oil tank needs to be cleaned and metal debris removed.
Temperature monitoring: Pay close attention to the temperature changes of the reducer during operation to avoid overheating affecting performance or even causing failures. Once the temperature is too high or other abnormal conditions are found, the cause should be checked and handled immediately.
Cleaning and protection: Clean the surface dust and oil regularly to prevent it from invading the interior and causing pollution and corrosion; pay attention to waterproofing and moisture-proofing to avoid damaging the internal structure of the machine.
Sealing and cleaning protection: Check the shaft end oil seal every quarter, and replace it in time if it leaks oil; clean the inside of the reducer regularly to keep it clean and dry.
Load and component inspection: It is strictly forbidden to operate over the rated torque, and regularly check the coupling alignment accuracy and worm gear tooth surface wear; check the bearing clearance every year, and replace the bearing when the axial clearance exceeds 0.3mm.
Long-term shutdown maintenance: When the shutdown exceeds 1 month, the old oil needs to be drained and anti-rust oil needs to be injected, and the gear needs to be manually turned to make the oil film evenly attached to each tooth surface; clean and replace the new lubricating oil before reactivation.






