Tips for using reducers mainly include installation, maintenance and lubrication.
Installation tips
Avoid excessive force: When assembling the harmonic reducer, avoid applying excessive force to the wave generator bearing part. The wave generator can be inserted smoothly by rotation.
Check flatness and screw holes: Confirm whether the flatness of the mounting surface is good, whether there is foreign matter in the screw hole, and ensure that the housing assembly part is chamfered and avoided to avoid interference with the rigid wheel or flexible wheel.
Tighten the bolts in diagonal order: Tighten the bolts in diagonal order in sequence, avoid tightening them at the specified torque at one time, first use a force of about half the specified torque to temporarily tighten, and then tighten them at the specified torque.
Maintenance tips
Keep clean: The assembly environment needs to be sufficiently clean, and avoid any foreign matter from entering the reducer during installation, otherwise it will cause serious consequences. Check the meshing state: After the wave generator is installed, check the meshing state of the flexible wheel and the rigid wheel. If there is any deviation, please adjust it immediately, otherwise the flexible wheel will be damaged.
Lubrication: Confirm that the meshing tooth surface and flexible bearing part of the reducer are always lubricated.
Lubrication skills
Choose the right lubricant: For horizontal cycloid reducers, oil pool lubrication is usually used, and make sure that the oil level is in the middle of the oil sight glass. If the ambient temperature is high or the working conditions are harsh, it is recommended to use circulating lubrication. Cycloid pinwheel reducers are generally lubricated with 40# or 50# mechanical oil at room temperature. In order to improve the performance of the reducer and extend its service life, it is recommended to use 70# or 90# extreme pressure gear oil.
Regularly change the lubricant: After the new reducer is refueled for the first time and runs for 100 hours, the new oil should be replaced and the internal dirt should be cleaned. After that, the lubricant should be replaced every six months under the 8-hour working system. If the working conditions are harsh, the oil change cycle can be appropriately shortened.






