Aluminum Worm Gearbox

Aluminum Worm Gearbox

Type:aluminum right angle gearbox
Model:025, 030, 040, 050, 063, 075, 090, 110, 130, 150
Reduction Ratio:1:25 ~ 1:100Color
Material:Housing: Aluminum for RV25-RV90, Cast Iron for RV50-RV150
Worm Gear: Copper-9-4#, Copper-12-2#
Worm Shaft: 20Cr, Carburized and Quenched, Surface Hardness 56-62HRC
Output Shaft: 45# Steel
Input Shaft: 20Cr Steel
Packaging:Carton and Wooden Case
Warranty:12 Months
Send Inquiry
Description
Technical Parameters

product-550-550

Aluminum worm gearbox is widely used in industrial, chemical, medical and other fields, its compact structure, low noise, high torque, light, easy to install and other advantages, popular and used.

 

The following are some precautions when aluminum worm gearbox is connected with the motor and the equipment:

 

1, the aluminum worm gearbox and the equipment connection: the aluminum gearbox is directly set on the equipment spindle, when the it is running, the anti-torque acting on the reducer box, and the anti-torque bracket installed on the reducer box or by other methods to balance. The machine is matched directly, and the other end is connected with the fixed bracket. The correct installation between the NMRV reducer and the mechanical equipment is similar to the correct installation between the NMRV reducer and the drive motor. The key is to ensure that the output shaft of the reducer and the driven part of the shaft concentricity is consistent;

 

2, the installation of the anti-torque bracket: the anti-torque bracket should be installed on the side of the reducer towards the working machine to reduce the additional bending moment on the working machine shaft. Elastomers such as rubber are used to prevent deflection and absorb the torque fluctuations generated by the coupling end of the anti-torque bracket and the fixed support;

 

3, the worm gearbox in the installation relationship with the equipment: in order to avoid the equipment spindle deflection and additional force on the reducer bearing, the distance between the reducer and the equipment should be as small as possible under the condition of not affecting the normal work, the value is 5-10mm. ,

 

4. Before connecting the motor with the aluminum worm gearbox, the key way of the motor shaft should be perpendicular to the tightening bolt. In order to ensure uniform force, screw the mounting bolts in any diagonal position first, but do not screw them tight, then screw the other two diagonal position mounting bolts and finally screw the four mounting bolts one by one.

 

Tighten the force bolt. All tightening bolts need to be fixed and checked by torque plate and according to the fixed torque data indicated.

Hot Tags: aluminum worm gearbox, China aluminum worm gearbox manufacturers, suppliers, factory, heli bevel gearbox, gearbox, aluminium gearbox, Aluminium Gearbox With High Torque, Gearbox Nmrv 040, bevel helical gear unit